Aluminum handle 6" long with 75-90-75 durometer
blade for most printing. Other blades available upon request.
Aluminum handle with triple durometer blade is recommended for chest prints. Notice bolts
are near the ends of the handle to provide support to the blade.
Aluminum is better than wood, because bolts go through the handle and
not the blade. With aluminum, pressure is constant the length of the
blade compared to pressure points on wood where bolts go through the
blade causing the blade to warp over time. All blades should be polished by
using the free Squeegee Sharpener that you make. We will custom cut to
any length desired and sell by the inch. For chest prints we recommend a
6" aluminum handle for a far superior printing experience than with
wood. Squeegee blades should be cleaned immediately after use, and
never left sitting in ink or with ink on them, because the ink will make
the blade become hard over time and then chip. See video "Squeegee Secrets."